Slimline Stainless Steel Rod Holder 30° – 316 Flush Mount 200mm

Highly polished 316 stainless slimline flush-mount fishing rod holder. 30° angle, 42mm internal diameter, 200mm intrusion. Compact rectangular base for narrow decks and coamings.

Keep a rod ready on the gunwale without eating deck space.

This slimline flush-mount rod holder is made from polished 316 stainless steel for Australian saltwater use. The low-profile base sits on narrow coamings where a large oval or cast head will not fit. A 30° shaft angle holds the rod slightly forward for trolling and drift fishing, and the 42mm bore takes most standard boat rods.

Why this holder • 316 stainless, highly polished — built for salt, not a season of shine • Slimline flush base — clean install on tight decks and cabin sides • 30° angle — rods sit working, not dead vertical • 42mm internal diameter — fits common spin and baitcaster butts • 200mm intrusion / 45mm cut-out — measure under the deck before you drill • 4 × 6mm mounting holes — four-point fix through the flange

Specifications • Material: 316 stainless steel, polished • Mount: slimline flush / through-deck • Angle: 30° • Internal diameter: 42mm • Cut-out: 45mm • Intrusion: 200mm • Mounting holes: 4 • Mounting screws: 6mm (screws not included)

Fitment note Confirm there is 200mm clear below the deck and that a 45mm hole will not hit a liner, tank or cable run. Seal the flange with a marine bedding compound.

Also see our deck and cabin hardware for matching cup holders and deck fittings.